Herunterladen Inhalt Inhalt Diese Seite drucken

Elektrischer Anschluss | Electrical Connection - Hautau SKA 30/2 Montageanleitung

Kettenantrieb 24 v dc
Inhaltsverzeichnis

Werbung

Elektrischer Anschluss | Electrical connection

zu verwenden: Vorschalteinheit VE 1 A mit vergossener Anschlussleitung 230 V AC (L = 5 m)
to use: Preconnection unit VE 1 A with encapsulated connection cable 230 V AC (L = 5 m)
Single-Antrieb | Single drive
Blindstecker
Blind connector
Tandem-Antrieb | Tandem drive
Blindstecker
Blind connector
A
1 2 3 4 5 6
Anschlussleitung durch die Öffnung der schwarzen Endkappe
führen. Anschluss gemäß Anschlussplan durchführen. Weitere
nicht benötigte Adern zur Vermeidung von Kurzschlüssen
isolieren. Anschlussplatine wieder in das Aluminiumgehäuse
schieben und die Endkappe aufstecken.
Seite | Page 16
SKA 30/2
SKA 30/2 Masterantrieb | Master drive
Verbindungsleitung mit Stecker ca. 1,5 m
Connection cable with plug ca. 1.5 m
SKA 30/2 Slaveantrieb | Slave drive
Farbbelegung und Funktion der Anschluss- und Verbindungsleitung
Colour assignment and function of the power/connection cable
Nr.
Funktion
1 2 3 4 5 6
No. Function
1
24 V 0 V
2
0 V 24 V
3
Bus A
4
Bus B
5
Meldekontakt 0,25 mm²
Signal contact
6
Meldekontakt 0,25 mm²
Signal contact
Hinweis: Der Meldekontakt ist ein potentialfreier Schliesserkontakt
und schaltet, wenn die Kette eingefahren (das Fenster ZU) ist.
Note: The signal contact is a potential-free normally open contact and
switches when the chain is retracted
Anschlussleitung mit Stecker
und Aderendhülsen
Power cable with connector
and ferrules
Anschlussleitung mit Stecker
und Aderendhülsen
Power cable with connector
and ferrules
Aderquerschnitt
Aderfarbe
Wire cross-section Wire colour
0,75 mm²
weiß | white
0,75 mm²
braun | brown
0,25 mm²
grün | green
0,25 mm²
gelb | yellow
grau | grey
rosa | pink
(the window CLOSED)
Lead the connecting cable through the opening of the black end
cap. Carry out the connection according to the connection diagram.
Insulate any other wires that are not needed to avoid short circuits.
Push the connection board back into the aluminium housing and
put on the end cap.
Kettenantrieb SKA 30/2 - Chaindrive SKA 30/2 | 501178
A
B
A
B
B
gelb
yellow
grün
rosa
green
pink
grau
grey
braun
brown
weiß
white
.

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis