DHC BT2400 Pro Benutzerhandbuch Seite 9

6. Select capacity. Available capacity range:
25 to 3000 CCA/SAE
25 to 2830 EN
25 to 2710 EN2
25 to 1985 IEC
JIS (by battery type)
25 to 1685 DIN
25 to 3600 CA/MCA
7. Confirm battery position by
selecting the YES/NO option of
"TEST IN VEHICLE?".
8. The tester will then check if the
user would like to proceed to an
In-Vehicle Test.
If YES, the tester will
automatically proceed to
the system test after the
battery test is completed.
If NO, the tester will perform only the battery test.
9. Temperature compensation. Aim the temperature sensor at the battery and
press ENTER.
10. Test result will be presented after test is completed, use directional keys to
review the test result. Select "PRINT" to print test result. Select "DONE" to
return to the main menu.
SURFACE CHARGE
If the tester detects a surface charge, a pop-up notification will ask the user to turn
on loads/headlights for 15 seconds to eliminate the surface charge.
Please note that vehicles with LED headlights and modern vehicle control
modules might not be able to eliminate surface charge within 15 seconds and the
9