DHC BT2400 Pro Benutzerhandbuch Seite 5

PRECAUTIONS FOR USING THE INTEGRATED PRINTER
To prevent overheating the integrated printer, it is not recommended to operate
the printer continuously without short breaks. The printer should be rested for at
least 1 minute for every 2 minutes of continuous use.
There is no need to be worried under normal operation, where one test only
requires one printout and continuous printing is highly unlikely. However, if the
integrated printer does start to get warm, please allow it to cool down by
temporarily halting any printing actions.
HOW TO REPLACE CLAMP SET
1. Detach the clamp set when in need of replacement.
2. Make sure the new clamp set is properly connected.
*Do not detach the cables unless necessary to ensure the pins are not exposed to
the moisture and acidic liquids which could cause rusting and corrosion.
INSTALL / REPLACE THE INTERNAL BATTERIES
The tester offers two different options for its internal batteries.
A. 6pcs AA batteries.
B. 2pcs 18650 rechargeable lithium batteries.
5