DHC BT2400 Pro Benutzerhandbuch Seite 17

VERISON
1. Select "VERSION" to check the current firmware version and serial number of
the tester.
CABLE DIAGNOSIS
1. Select "CABLE DIAGNOSIS" to perform self diagnosis of the cable set.
2. Follow on screen instructions.
1. Clamp on a battery that the voltage is above 12.4V. And make sure its
posts are clean.
2. Press ENTER to start.
3. Select START to start the cable diagnosis.
4. Result will be shown on the Test Report, use left and right key to switch
between positive/negative cable test result explanation.
HISTORY
TEST RESULT
1. Select "HISTORY" and then enter "TEST RESULT" to review the test results
within the last 7 days.
2. Select between test types & days for reviewing.
3. Select "ERASE" will clear all the test records that saved in the tester.
TEST COUNTER
1. If the "TEST COUNTER" is selected. The user may review the number of the
tests that have been performed. Or print out the counter if needed.
17