Mounting Instructions - Carrier WTC-RCI-D Installationsanweisungen

Mounting instructions

Mounting hardware with a separate sub-base
is provided with the device for installation on
dry wall or on an electrical junction box.
Turn off the power before any kind of
servicing. All wiring must comply with
national and local electrical codes.
General recommendations
The device should not be installed on an
■
exterior wall.
The device should not be installed near a
■
heat source.
The device should not be installed near
■
an air discharge grill.
The device should not be installed in a
■
place where it can be directly affected by
the sun.
Install the device in an area that provides
■
proper device ventilation. Nothing must
restrain air circulation to the device.
Models equipped with a motion sensor
■
should be installed at a height where
people will pass within its detection zone.
Models equipped with a CO
■
should be used in spaces that are
periodically unoccupied (e.g. during
evening or night time hours).
Maintenance
The WTC Room Control Interface does not
require any special maintenance. Clean the
WTC-RCI-D/-DC/-DM/-DCM series by
polishing with a soft dry cloth.
4
Installation procedure
The Room Control Interface can be
mounted on a dry wall using supplied screws.
To mount the room control interface on
the wall
1. Remove the security screw from the
device (see Figure 3 below).
2. Open the device by pressing in the two
(2) tabs on the bottom of the device with
a flat screwdriver and pulling the bottom
side of the front plate out.
3. Pull all cables (15 cm) out of the wall,
and insert them through the central hole
of the back plate.
4. Align the back plate with the wall and
mark the location of the mounting holes
on the wall. Make sure to orient the proper
side of the back plate facing upwards.
5. Remove the back plate and drill holes in
the wall if necessary.
6. Install anchors in the wall if necessary.
7. Make sure that the mounting surface is
sensor
flat and clean.
2
8. Screw the back plate onto the wall.
Do not overtighten.
9. Plug the wire(s) into the connector(s).
10. Gently push excess wiring back into the wall.
11. Set jumpers (see Figure 4).
12. Reattach the front plate and make sure it
clips tightly into place. Start by hooking
the top in place, and then clip the bottom
edge into place.
13. Install the security screw.
Figure 3: Mounting WTC Room Control Interface
Wall Anchors
Security Screw