4.1.2
USING THE SCREEN (DIVUS CIRCLE ONLY)
Depending on the project, the DIVUS CIRCLE will show a single image or multiple buttons with names. Push the
image or the desired button to call the corresponding unit.
4.1.3
USING THE SCREEN (DIVUS CIRCLE small+ ONLY)
The display of the DIVUS CIRCLE small+ is normally switched off. It is activated by the motion sensor or direct
touch and remains active for 5 minutes after use before it switches off again. On a CIRCLE small + configured for
multiple units, first make sure the name of the desired callee is shown (or move there using the shown arrows)
and then click on the name to start the call.
4.2
OPENING THE DOOR
4.2.1
MANUALLY
It might sound stupid, but in quiet a lot of situations it may be the most natural and preferred option to open the
door manually. In such cases, the DIVUS CIRCLE is used for calling and to see who is standing outside and then
the door opening is done in the good old way
4.2.2
FROM INSIDE
We recommend to use the DIVUS VIDEOPHONE app on a DIVUS touch panel as counterpart of the DIVUS CIRCLE
for the inside of your intercom system. If used in conjunction with a DIVUS KNX SERVER, you can command a
KNX device through the VIDEOPHONE app. That means the door opening function can be achieved through the
The default option is to send the DTMF tone assigned to the door opening function (ACCESS 1) to the CIRCLE
directly. The CIRCLE itself will then take care of forwarding that command to the configured output(s) which can
be the integrated relay or one (or more) of t
4.2.3
ON THE MOVE
The new DIVUS VIDEOPHONE MOBILE also enables you to participate in your own Intercom system via Cloud -
i.e., to be able to answer the call from the outdoor intercom when it rings and possibly also to open the door/gate.
More detailed information is available in the
without special technologies.
DIVUS VIDEOPHONE MOBILE
DIVUS CIRCLE user manual .
manual.
49