Screw Mounting - eQ-3 homematic IP basic HmIP-WTH-B-2 Installations- Und Bedienungsanleitung

Start-up
7). Make sure that the electronic unit properly engages into the
mounting plate.
• Fix the adhesive strips on the back side of the mounting plate in
the provided area. You should be able to read the letters ("TOP")
on the back side (see figure 8).
• Remove the protective film from the adhesive strips (see figure 9).
• Press the assembled wall thermostat with the back side to the
wall in the position where it should subsequently be attached (see
figure 9).
5.2.2

Screw mounting

For mounting the wall thermostat by screws, please proceed as follows:
• Choose a site for installation.
Make sure that no electricity or similar lines run in the wall at this
location!
• Position the mounting plate on the desired site on the wall. Make
sure that the arrows on the back side of the mounting plate point
upwards (see figure 10).
• Use a pen to mark the positions of the two bore holes according
to the mounting plate with a distance of 60 mm on the wall (see
figure 10).
• Drill the marked holes (see figure 11).
If you are working with a stone wall, drill the marked two 5 mm holes
and insert the plugs supplied. If you are working with a wooden wall,
you can pre-drill 1.5 mm holes to make screws easier to insert.
• Use the supplied screws and plugs to fasten the mounting plate
to the wall (see figure 11).
Insert the electronic unit (A) into the mounting plate (see figure
•
12). Make sure that the electronic unit properly engages into the
mounting plate.
44