Herunterladen Diese Seite drucken

Canon ImagePROGRAF iPF830 Installations-Handbuch Seite 10

Druckergestell

Werbung

4
a

各用  只 M4 六角螺栓拧紧 [ 辊单元 ] 和 [ 导轨单元 ] 重合在一起的孔 (a),直
到拧不动。
[ ロールユニット ] と [ レールユニット ] の重なり合った穴 (a) を、各1本の M4 六
角ボルトで回らなくなるまで締め付けます。
• In the overlapping holes (a) of the Roll Unit and Support Rails, tighten one M4
hex bolt on each end firmly.
• Dans les orifices superposés (a) de l'unité de rouleau et des rails de support,
serrez fortement un boulon hexagonal M4 à chaque extrémité.
• Nei fori che si sovrappongono (a) dell'Unità rotolo e delle Guide del supporto,
a
serrare fino in fondo una vite esagonale M4 su ciascuna estremità.
• Ziehen Sie die M4-Sechskantbolzen an jedem Ende in den übereinanderliegenden
Löchern (a) der Rolleneinheit und Stützschienen fest an.
• En los orificios superpuestos (a) de la Unidad de rollo y de los Raíles del soporte,
apriete firmemente un perno hexagonal M4 en cada extremo.
• [ 롤 유닛 ] 과 [ 레일 유닛 ] 이 겹친 구멍 (a) 을 각각 1 개의 M4 6 각 볼트로 돌아가
지 않을 때까지 조입니다 .
Прочно затяните по одному шестигранному болту M4 на каждом конце в
местах совпадения отверстий (a) блока рулона и опорных направляющих.
• Nos orifícios sobrepostos (a) da Unidade de rolo e dos Trilhos de suporte, aperte
firmemente um parafuso hexagonal M4 em cada extremidade.
从 [ 辊单元 ] 上去掉胶带和包装材料。
[ ロールユニット ] からテープや梱包材を取り除きます。
Remove tape and packaging material from the Roll Unit.
• Retirez le ruban adhésif et le matériau d'emballage de l'unité de rouleau.
• Rimuovere il nastro adesivo e il materiale di imballaggio dell'Unità rotolo.
• Entfernen Sie das Klebeband und Verpackungsmaterial von der Rolleneinheit.
• Retire la tapa y el material de embalaje de la Unidad de rollo.
[ 롤 유닛 ] 에서 테이프와 포장재를 제거합니다 .
Удалите ленту и упаковочный материал с блока рулона.
• Remova a fita e o material da embalagem da Unidade de rolo.


Werbung

loading