Operation And Use; Filling The Appliance; Starting Ice Production - Silvercrest SEMD 150 A1 Bedienungsanleitung

Operation and use

Filling the appliance

♦
If the
water tank to begin ice cube production . Add water .
NOTE
► Before filling the appliance, make sure that the cap is screwed tight onto
the drain opening
again .
♦
Open the access panel for the water tank
least 0 .9 litres of water at a temperature of between 7°C and 30°C to the
water tank .
♦
Ensure that the water level never exceeds the MAX marking .
♦
Close the access panel for the water tank

Starting ice production

♦
Select the desired ice cube size with the selection buttons
(medium) or L (large) . If you only want to cool your drinks moderately, we
recommended using small ice cubes . For a more intense cooling effect, use
large ice cubes . Note that the melting ice cubes will dilute your drink .
♦
Press the On/Off button
until the On/Off button
♦
During ice production, the rotating
ice cube size are shown on the display
♦
Depending on the ice cube size selected, you will hear the ice cubes drop-
ping into the ice compartment after about 6–9 minutes . To dispense the ice
cubes, hold the ice cup
lightly against the ice cube dispenser button
drop into the ice cup
SEMD 150 A1
symbol lights up on the display
. Otherwise, the filled water will flow straight out
. While the ice cubes are being dispensed, the
symbol appears on the display
Ice cube size
S
M
L
, there is not enough water in the
. Using the ice cup
.
to start ice production . Ice production continues
is pressed again .
symbol and the letter for the selected
.
under the ice outlet
. The ice cubes will then
.
Production time
6–7 minutes
7–8 minutes
8–9 minutes
, add at
S (small), M
and press the ice cup
GB │ IE │ 25 ■