Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
NOTE
►
The first production phase lasts a little longer than the following ones .
►
During the initial production phases, the ice cubes may be a little smaller
than later on .
►
The production times may vary depending on the ambient temperature .
♦
Remove the ice cup
output .
♦
When the ice compartment is full, the
You will hear 5 beeps . Ice cube production is stopped .
♦
If the water level is too low, the
will hear a beep . Ice production stops . If you want to continue producing ice
cubes, fill the water tank and restart ice production .
NOTE
►
To check how many ice cubes have already been made, open the ice
compartment cover
►
It is possible that not all ice cubes are pushed into the ice outlet, but get
stuck in front of the chute . If this happens, push the ice cubes with the ice
scoop or a spoon into the ice outlet .
►
Do not top up the water if the ice compartment is already full . Use up some
of the ice first .
►
If the ice has been in the ice compartment for a long time, the ice cubes
can freeze onto each other . If this happens, no ice can be dispensed even
though the ice compartment is full . Use the supplied ice scoop
separate the ice cubes in the ice compartment . Remove the ice cubes .
►
If you would like to store the ice cubes for a longer period, place them into
a freezer compartment in a suitable container .
►
If the drip tray
Pull the drip tray
from the drip tray
tray
■
26
│
GB │ IE
from the ice cube dispenser button
.
is full, remove the ice cup
straight out of the appliance . Remove the drip grille
and empty the tray . Replace the drip grille in the drip
and push it back into the appliance .
symbol appears on the display
symbol will flash on the display
from the drip tray
to stop the ice
.
and you
to
.
SEMD 150 A1
Werbung
Inhaltsverzeichnis
