Troubleshooting - Veripart VPTMKV85 Benutzerinformation

6. TROUBLESHOOTING

You can solve some problems easily yourself using the table below. Caution!
!
Attention!
• Before solving the problem, switch off the power supply.
• If the following descriptions do not solve your problem, please contact
our customer service:
www.coolblue.nl/en/customer-service
• Only a quali ed electrician or authorised person may solve the faults
not contained in this manual. Repairs carried out by unauthorised
persons may cause injury and/or serious damage to persons and
property.
PROBLEM
The appliance
does not cool
at all
The door does
not open
easily.
POSSIBLE CAUSE
- The temperature control knob is in
the highest position.
- The plug is not inserted properly.
- There is no voltage on the socket.
- The fuse is blown or defective.
- The appliance is installed in
a place where the ambient
temperature is less than 16°C,
such as a balcony, garage or
storage room.
- You tried to open the door
immediately after closing.
SOLUTIONS
- Switch the thermostat to
another position.
- Insert the plug properly.
- Open the door and check if
lamp is on. If the lamp is off,
there may be no voltage on
the socket. Have the socket
repaired by an electrician.
- Check the fuse and replace if
necessary.
- Install the appliance in a
protected location where
the ambient temperature
is higher than 16°C. If
the appliance is installed
in a room with too low a
temperature, the internal
cooling system may not
operate correctly.
- Wait a few seconds between
closing and re-opening the
door.
58