Troubleshooting - Veripart VPKK701 Benutzerinformation

6. TROUBLESHOOTING

!
You can solve some problems easily yourself using the table below.
ATTENTION!
• Before solving the problem, switch off the power supply.
• If the following descriptions do not solve your problem, please contact
our customer service:
www.coolblue.nl/en/customer-service
• Only a qualified electrician or authorised person may solve the faults not
contained in this manual. Repairs carried out by unauthorised persons
may cause injury and/or serious damage to persons and property.
PROBLEM
The appliance
does not cool at
all
Abnormal noise - The appliance is not stable/level.
POSSIBLE CAUSE
- The thermostat is set to '0'.
- The plug is not inserted properly.
- There is no voltage on the socket.
- The fuse is blown or defective.
- Where is the device installed? Is it
located on a balcony, in a garage,
storage room or other place where
the ambient temperature is less
than 10°C?
- The appliance is in contact with the
wall or other objects.
SOLUTIONS
- Switch the thermostat to
another setting (e.g. 4)
- Insert the plug properly.
- Open the door and check if
lamp is on. If the lamp is off,
there may be no voltage on
the socket. Have the socket
repaired by an electrician.
- Check the fuse and replace if
necessary.
- Install the appliance in a
protected location where the
ambient temperature is higher
than 10°C. If the appliance
is installed in a room with
too low a temperature, the
internal cooling system may
not operate correctly.
- Readjust the appliance's
adjusting legs.
- Move the appliance slightly.
54