Veripart VPTMKV85 Benutzerinformation Seite 61

PROBLEM
There is too
much frost and
ice.
The compressor
works
continuously.
The lamp does
not work.
The side panels
are hot.
POSSIBLE CAUSE
- The door is not closed properly.
- The door gasket is deformed or
dirty.
- The products are not packed
correctly.
- The temperature is set incorrectly.
- The appliance is fully loaded and
set to the lowest temperature.
- The set temperature in the
appliance is too low and the
ambient temperature is too high.
- The temperature is set incorrectly.
- Many products are placed at the
same time.
- The room temperature is too high.
- The food placed in the appliance
was too hot.
- The door is not closed properly.
- The lamp is broken.
- The lamp is in the standby
position.
- This is normal. The heat
exchanger components are on
the side.
SOLUTIONS
- Find the cause of the door
not closing properly, remove
or move possible obstacles.
- As a result, the door does
not close properly. Clean
the seal and repair the
deformation. If necessary,
replace the seal, contact
customer service.
- Pack the products better.
- Please refer to Section 4.
- Set a higher temperature.
Please refer to Section 4.
- Set a higher temperature.
Please refer to Section 4.
- Please refer to Section 4.
- Wait a few hours and then
check the temperature again.
- Please refer to Section 4.
- Allow food to cool to room
temperature before storing.
- See the previous section.
- Please contact our customer
service.
- Close and open the door.
60