Installing The Fronius Dc Box 60/12; Dowels And Screws; Selecting A Location - Fronius DC Box 60/12 MET Bedienungsanleitung

Installing the Fronius DC Box 60/12

Dowels and Depending on the surface, different dowels and screws may be required for installing the
Screws Fronius DC Box 60/12. Therefore, these dowels and screws are not part of the scope of
delivery for the Fronius DC Box 60/12.
The installer is responsible for selecting the proper dowels and screws.
Selecting a Loca- When selecting the location, please observe the following criteria:
tion -
-
-
-
-
48
Install on a solid surface.
The ambient temperature may not fall below -25 °C nor exceed +60 °C
The Fronius DC Box 60/12 may be installed outside in shelteredareas. Avoid direct
contact with moisture.
Should be protected from direct sunlight and direct exposure to theelements.
Should be installed under the solar modules where possible.
NOTE! To prevent warping of the
Fronius DC Box 60/12, the device
should be installed only on a flat
surface!