Sleep Mode; Night Mode; I Comfort Function; Room Temperature Function - DeLonghi ONE Inverter 9K Installationsanleitung

SLEEP MODE

Night mode

To activate the night function in the COOL, DRY and HEAT
modes, press the SLEEP button. The symbol
the display. To deactivate the night function, press the SLEEP
( ) button again.
During operation in the night mode, the set temperature in-
creases by 1 °C in the first hour of operation and by another
1 °C in the following hour, maintaining this increase of 2°C
in the subsequent hours.
Selecting the night function in the heating mode, the set
temperature decreases by 1 °C in the first hour of opera-
tion and by another 1 °C in the following hour, maintaining
this decrease of 2°C in the subsequent hours with the fan
operating at minimum speed.

I COMFORT FUNCTION

Press the I COMFORT (
appears on the display.
This function is used to obtain the required climate in
the exact point where the remote control is located.
The temperature of reference is that measured by the
sensor in the remote control, bypassing the temperature
sensor inside the air conditioner.
The remote control must always by pointed at the
unit.
If no signal is received from the remote control for
11 minutes, the unit will once again refer to its own
internal sensor

ROOM TEMPERATURE FUNCTION

Press the ROOM TEMPERATURE
F Logic remote control) for the various modes of measur-
ing the temperature in the room where the appliance is
installed.
A few display examples are given in the table:
I-COMFORT function not active
Remote control display
Set temperature
Temp. measured by
indoor unit sensor
Function unavailable
I-COMFORT function active
Temp. measured by
remote control sensor

TURBO POWER FUNCTION

To activate the TURBO POWER function, press the
button. The symbol appears on the display.
In the COOL or HEAT mode, the air conditioner will auto-
matically operate at maximum power. To deactivate this
function just change the fan speed or press the
again.
SINGLE SPLIT
appears on
), )button and the symbol
button (only on the
Indoor unit display
Set temperature
Set temperature
Set temperature
button
ON OFF
!
NOTE: Under FAN and SMART modes, this function is not
available.
ON OFF
!
MODE
-
+
ON OFF
ON OFF
!
USER
INTELLIGENT REMOTE CONTROL
USER
INTELLIGENT REMOTE CONTROL
!
USER
INTELLIGENT REMOTE CONTROL
°C
USER
INTELLIGENT REMOTE CONTROL
ENGLISH
11