cecotec bolero DRESSCODE 7200 Bedienungsanleitung Seite 33

ENGLISH
For the models equipped with hot valve, connect it to a hot water tap with the hot water supply
hose. Energy consumption will decrease automatically for some programs.
Connect the inlet hose following one of the below methods:
Connection between ordinary tap and inlet hose.
Fig. 8.
1. Loosen the clamp nut and four bolts.
2. Tighten the clamp nut.
3. Press slide bushing and insert inlet hose into connecting base.
4. Connection finished.
Connection between screw tap and inlet hose.
Fig. 9.
Tap with threads and inlet hose.
Special tap for washing machine.
Connect the other end of inlet hose to the inlet valve at the backside of product and fasten the
pipe tightly clockwise. Fig. 10.
Drain hose
Note
- Do not kink or protract the drain hose.
- Position the drain hose properly, at 60-90 cm from the floor.
There are two ways to place the end of the drain hose:
- In a drainpipe. It is recommended to use a vertical tube.
- In a sink's drainpipe, over the trap.
Fig. 11.
If the machine has drain hose support, it can also be installed on a sink or a tank, like the
following. Fig. 12.
Warning
When installing drain hose, fix it properly with a rope. If drain hose is too long, do not force it
into washing machine as it will cause abnormal noises.
4. OPERATION
Note
- Please make sure the appliance is properly installed before operating it.
64
- Before washing the clothes for the first time, the product shall be operated in one round of
the whole procedures without the clothes inside.
QuickStart
Before washing
1. Plug the device into a power supply.
2. Open the tap.
3. Load.
4. Close the door.
5. Add detergent.
Fig. 13.
Note
Detergent must be added in "case I" only after selecting pre-washing for machines with this
function.
Washing
1. Turn the device on.
2. Turn the knob to select the desired programme.
3. Select function or use the default one.
4. Press Start.
Fig. 14.
Note
If any of the default options is selected, step 3 can be skipped.
After washing
The appliance will beep, or the display will show "End".
Using the washing machine
Before each washing
- The washing machine should be operated within a temperature range of 0-40 °C. If used
under 0°C, the inlet valve and draining system may be damaged. If the machine is placed or
operated in rooms at 0 °C or below, it should be transferred to normal ambient temperature
to ensure the water supply hose and drain hose are not frozen before use.
- Check the labels and the product instructions when using detergent before washing. Use
non-foaming or less-foaming detergent suitable for machine washing.
- Check the label. Fig. 15.
- Empty the pockets of the clothes to be washed. Fig. 16.
BOLERO DRESSCODE 7200 / 7200 STEEL / 8200 / 8200 STEEL
ENGLISH
65