Pattfield Ergo Tools PFS200G Originalbetriebsanleitung Seite 54

SANDING PAPER / VELCRO
1 Remove any dust or debris from the
sanding pad 4.
Caution! Make sure the tool is
switched off and unplugged.
3 To remove the sanding paper carefully
peel it off the sanding pad 4.
Do not use the same sanding paper
for metal and wood.
SANDING ROLL / CLIPS
1 Remove any dust or debris from the
sanding pad 4 and open the sandpaper
clip 5 at the front of the tool.
Caution! Make sure the tool is
switched off and unplugged.
3 Turn the tool around and open the
sandpaper clip 5 at the rear of the tool.
106 EN
2 Use a velcro sanding paper of 90 x
187 mm. Align the holes in the sand-
ing paper with the ones in the sanding
pad 4 and press the sanding paper into
place.
2 Use a 90 mm wide sanding roll and cut
it to a length of 240 mm.
Place the sanding paper centric on the
sanding pad 4. Fold the sanding paper
under the sandpaper clip 5and close it.
4 Fold the sanding paper under the sand-
paper clip 5 and close it.
Do not use the same sanding paper
for metal and wood.
1
3
1. 1.
1
2. 2.
3
1. 1.
2. 2.
2
2. 2.
2
1. 1.
4
EN 107