Veratron VMH Serie Bedienungsanleitung Seite 14

VMH 14 CONFIGURATION
1. READ THE VMH 14 CONFIGURATION
Launch the "VMH 14" App and read the current
configuration of the device by "tapping" the
smartphone onto the NFC symbol on the
devices rear side.
The READ operation is mandatory before the
WRITE operation is allowed.
After the readout, the App will be set with the
current configuration.
NOTE: The antenna position on the
smartphone depends on the model.
Please refer to the smartphone manufacturer
manual.
2. SELECT GAUGE TYPE
Tap the "Data to display" item in the "Display
Settings" section to choose the data you want
to display on the VMH 14.
Note: See the complete list of supported gauge
types in the "Supported Configurations" table
of this document.
3. SET UNITS AND INSTANCE
Define the unit for the displayed value if more
than one is available (see "Supported
Configurations" table).
Set the instance for the displayed value (e.g.
Engine No. or Tank No.) so that the VMH 14 will
show your data on the display.
CONFIGURATION
B001225