Veratron VMH Serie Bedienungsanleitung Seite 9

INSTALLATION WITH SPINLOCK
The panel width may be within a range of 1 to 12 mm. The drill hole must have a diameter of 52 mm [A].
• Do not drill holes or ports in load-bearing or stabilizing stays or tie bars!
• Note the necessary clearance behind the drill hole or port at the installation location. Required
mounting depth: 40 mm.
• Drill small ports; enlarge and complete them, if necessary, using taper milling tools, saber saws,
keyhole saws or files. Deburr edges. Follow the safety instructions of the tool manufacturer.
1. Create a circular hole in the panel considering
the device dimensions. [A]
2. Remove the spinlock and insert the device
from the front. [B]
A
C
WARNING
3. Adjust the spinlock as shown in picture [C]
according to the panel thickness.
4. Carefully screw in the spinlock by hand at
least two turns.
5. Insert the connector.
B
INSTALLATION
B001225