Veratron VMH Serie Bedienungsanleitung Seite 8

INSTALLATION
Before beginning, disconnect the negative terminal on the battery, otherwise you risk a short circuit.
If the vehicle is supplied by auxiliary batteries, you must also disconnect the negative terminals on
these batteries! Short circuits can cause fires, battery explosions and damages to other electronic
systems. Please note that when you disconnect the battery, all volatile electronic memories lose their
input values and must be reprogrammed.
BEFORE THE ASSEMBLY
1. Before beginning, turn off the ignition and
remove the ignition key. If necessary, remove
the main circuit switch.
Disconnect the negative terminal on the
battery. Make sure the battery cannot
unintentionally restart.
Refer to the safety instructions of this
document.
2. Place the device at least 300 mm away from
any magnetic compass.
3. Consider that the device must be connected
to an VMH master device and/or other VMH
14 gauges (maximum 16 gauges in a daisy
chain per master).
WARNING
INSTALLATION
B001225