Configuration Via Interface & Fieldcare Device Setup Pc Configuration Software - Endress+Hauser RIA16 Bedienungsanleitung

RIA16
Menu Operating function
Parameter
Operating User code
parameters CODE
PARAM
0000 to 9999
NAMUR
NAMUR
Default
Edit
NAMUR 20.5*
N2050
NAMUR 3.80
to NAMUR
21.0
Service Service code
SERV SCODE
*) only if "Edit" has been selected for NAMUR
**) only if "TEXT" has been selected for DIMENSION
***) only available for service personnel
5.4 Configuration via interface & FieldCare Device Setup PC
configuration software
#
Warning!
The device must be configured outside the hazardous area.
"
Caution!
The device can assume undefined states while configuring with FieldCare! This can result in the
undefined switching of outputs and relays.
To configure the device with the FieldCare Device Setup software, connect the device to your
PC. You need a special interface adapter for this purpose - the Commubox FXA291 (see Chapter
'Accessories').
The 4-pin connector of the interface cable must be plugged into the corresponding socket inside
the device and the USB connector must be plugged into a free USB slot on the PC.
To establish a connection with the device, please follow the FieldCare Operating Instructions.
To then configure the device itself, follow these Operating Instructions for the device. The entire
Setup menu, i.e. all the parameters listed in these Operating Instructions, can also be found in
the FieldCare Device Setup.
Endress+Hauser
Operating function
Default / Parameter
Choice
Program name
PNAME
0000
NAMUR 3.6*
N_360
dEF 0 to NAMUR
Edit 20.5
NAMUR 21.0*
N2100
20.50 NAMUR 20.5
to 25 mA
Parameter reset***
PRSET
- - - - Yes
No
Operating the field display unit
Operating function
Default / Parameter
Choice
Firmware version
FWVER
NAMUR 3.80*
N_380
3.60 NAMUR 3.6 to
NAMUR 20.5
Test
TEST
21.00 off
Open Collect.
Display
Yes
No
Default /
Choice
3.80
OFF
OUT
DISP
37