Cyclic Process Data Output (Pdout) - wohner OMUS C14 Connect Plus Bedienungsanleitung

OMUS®C14 Operating Instructions

19.2 Cyclic process data output (PDOUT)

Cyclic process data output is sent from the IO-Link-Master to the OMUS®C14 for device
control.
Subindex Bit offset
1 0
NOTE:
!
Page 62 of 71
Name
Bit 7: Control Phase L3
(Configuration for 1~ operation
required)
Bit 6: Control Phase L2
(Configuration for 1~ operation
required)
Bit 5: External stop signal
(1: Stop device, 0: no effect)
Bit 4: Control Phase L1
(Configuration for 1~ operation
required)
Bit 3: Reserved
Bit 2: Error acknowledgement
(1: Acknowledge Error, 0: no effect)
Bit 1: Reserved
Bit 0: Load control
(1: control active, 0: inactive)
The "External stop" signal causes the load to stop immediately but
does not ignore control requests that are detected afterwards.
94 641 000 B
Datatype
Bool
Bool
Bool
Bool
Bool
Bool
Revision 09.2022