Zodiac YACHTLINE 440 Eignerhandbuch Seite 40

BUOYANCY CHAMBER – INSTALLING THE
BUOYANCY CHAMBER ON THE HULL
II-1-FITTING THE BUOYANCY CHAMBER ON THE HULL
NOTE:
1
To facilitate the positioning of the buoyancy chamber, apply liquid soap (A) to the hull rails.
2
Position the buoyancy chamber's (b) bolt rope (a) on the hull's rail.
3
- Pull the buoyancy chamber towards the boat's stern. (do not forget to guide the upper bolt
rope (C).
- Repeat for the other side of the buoyancy chamber
IF THE BUOYANCY CHAMBER WAS STORED AT A TEMPERATURE
BELOW 0°C / 32°F, LEAVE IT AT 20°C / 68°F FOR 12 HOURS BEFORE
UNFOLDING.
YOU CAN INFLATE THE NON-INSTALLED BUOYANCY CHAMBER
(PRESSURE 240MB) AND LET IT STABILIZE FOR AROUND ONE HOUR.
THEN DEFLATE IT.
The buoyancy chamber is fitted to the hull with the buoyancy tube
C
Page 10 / 28
deflated.