Assembly; Remove/Insert Battery; Mounting The Saw Chain - Parkside PAHE 20-Li B2 Originalbetriebsanleitung

and serious injuries to the per-
son working with the device.
• Secure the device well during
transport to prevent damage to
the device and injuries.
• Before use, check the device for
loose fastenings and damaged
parts, such as cracks in the cut-
ting attachments.
• Wear non-slip protective shoes
and close-fitting clothing.
• Do not use any accessories
that are not recommended by
PARKSIDE. This can result in
electric shock or fire.
Observe the safety in-
formation and notes on
charging and proper use as
shown in the instruction
manual for your battery and
charger from the Parkside
X 20 V Team series. A de-
tailed description of the
charging process and further
information can be found in
the separate operating in-
structions.

Assembly

Remove the battery from the
device before carrying out
any work on the device.
Only use original parts.
Dismantling is carried out in reverse
order.

Remove/insert battery

1. To remove the battery (11) from the
device, press the release button on the
battery and pull the battery out.
2. To insert the battery (11), push the
battery along the guide rail into the
device. You will hear it click into place.
Only insert the rechargeable
batteries once the device is
completely assembled. Risk
of injury!

Mounting the saw chain

Wear cut-resistant gloves while
working with the saw chain.
Pay attention to the correct rotation
direction of the saw chain (2). This
is specified on the chain wheel co-
ver (5)and on the blade (1).
Tension the saw chain in accordan-
ce with the first 5-6 steps.
See section "Tensioning the saw
chain".
1. Place the device on a level surface.
2. Remove the sprocket cover (5) by loos-
ening the wing nut (3)
3. Place the sawing chain (2) into the bla-
de groove. Place the sawing chain (2)
into the chain sprocket (25).
4. Place the blade bar (1) and saw chain
(2) onto the rail bolts (24). When the
nose on the right below the guide bolt
sits in the lower round recess on the
blade bar, the blade bar is placed cor-
rectly. It is normal for the saw chain (2)
to sag.
5. Put the chain wheel cover (5) on. Only
lightly tighten the wing nut (3) of the
chain wheel cover as the saw chain
must still be tensioned.
6. Tension the saw chain (2) by turning
the ring (4) of the chain tensioning
GB IE
.
37