Setting - AVer AVerVision A30 Bedienungsanleitung

Setting

 Capture Resolution: Select a resolution for the captured images.
 13M: Apply the 4208x3120 resolution to the captured images.
 Normal: The resolution of the captured images will be based on the selected resolution in the
Output Display (System > Output Display).
 Capture Quality: Select a quality for the captured images.
 Capture Type: Select Single to manually capture one image at a time. Select Continuous to
continuously capture images based on the setup Capture Interval. To stop continuously capturing
images, press the Capture button on the Remote Control.
 Capture Interval: If Continuous is selected in the Capture Type above, you can further set up
an interval.
 Storage: To set up this funcion, remove the USB cable from the unit first. Select a storage to store
the capture images or recording videos. Options include Embedded or USB Drive.
[Note]
1. The unit will automatically detect whether an USB drive has been connected. If an USB drive is
connected, the unit will automatically assign USB Drive to store data.
2. The internal Embedded storage can only store images with a maximum of 200 frames. If you
want to store videos, please connect an USB drive to the unit.
 Format: To set up this funcion, remove the USB cable from the unit first. You can format the
Embedded or USB Drive storage to erase all the data permanently.
 USB to PC: To set up this funcion, remove the USB cable from the unit first. When connecting the
unit to PC through the USB cable, you can either select Camera to use it as a Webcam, or select
Storage if you want to transfer the images or recordings from the unit to your PC.
 USB Streaming Resolution: To set up this funcion, remove the USB cable from the unit first.
Select a streaming resolution. Options include Max to 4K and Max to 1080P.
 Flicker: Select 50Hz or 60Hz. Some display devices cannot handle high refresh rates. The image
will flicker a couple of times as the output is switched to another refresh rate.
14