Lighting The Stove For The Rst Time - WANDERS Black Pearl Bedienungsanleitung

Turn the valve in the ue gas pipe  open. Slide the
primary air valve  and the secondary air valve  open
to their maximum positions. Open the door and put some
balls of paper or some relighters inside the stove and
place some wood kindling on top. Light the kindling and
leave the door ajar to let in extra air and, if necessary, slide
the ashpan  a bit open. Once the stove is burning, which
is after about ve minutes, you may close the door and the
ashpan again. Do not place more than three logs in the
stove at a time. Be sure there is always enough ventilation
when the stove is burning. If you want to temper the re,
you must rst close the valve in the ue tube and then
close the air supply.
Avoid nger marks
!
Do not touch the glass of the stove with your
ngers. Finger marks will burn into the glass and
cannot be removed later.
It is prohibited to light the stove with liquids like
petrol or spirits.
Do not have the cooker hood on in the room
where you operate your stove. Never touch the
varnished parts when you heat your stove.

Lighting the stove for the rst time

Discolouration of walls, ceilings and grates
!
The walls, ceilings and grates may show some discolouration after lighting your hearth. This is caused
by the dust particles that burn in the convection cover. This is a natural process for which WANDERS
cannot be held responsible. To minimize discolouring we refer to the advice given for atmospheric
hearths. Your installer can give you more information about this.
When you light the Black Pearl for the rst time, the hearth must still 'anneal' and temper itself. The unit has
a heat resistant lacquer which must burn in the stove at temperatures above 400 °Celsius. This will happen
during the rst few times of lighting as the stove and temperatures rise to 600 °C. Though this may give an
unpleasant smell, it is otherwise harmless. It is advisable to keep the stove burning with limited fuel for at
least 6 hours when lighting the stove for the rst 4 or 5 times. Air the room well when the stove is burning.
Make sure that any cooking hood is not turned on when the stove is burning; a cooking hood extracts the
combustion air that the stove needs.
Some deposit may form on the glass panes of the stove when you 'anneal' your hearth. You can easily remove
this deposit with a damp cloth after the stove has cooled down. You can also use some cleansing agent for
ceramic rings. Please make sure you do not leave any nger marks on the clean glass. Finger marks burn into
the glass and cannot be removed later.




19