Environmental Protection; Before Startup - Kärcher HD 7/11-4 Cage Bedienungsanleitung

Safety valve
The safety valve opens when the overflow
valve is defective.
The safety valve is set by the manufacturer and
sealed. Setting only by customer service.
Not all unit models are equipped with a
safety valve.
Thermostat valve
The thermal valve protects the high-pres-
sure pump from unacceptable heating dur-
ing circuit operation.
Not all unit models are equipped with a
thermostat valve.
Pressure switch
If the lever on the trigger gun is released
the pressure switch turns off the pump, the
high pressure jet is stopped. If the lever is
pulled the pump is turned on again.
Not all unit models are equipped with a
pressure switch.

Environmental protection

The packaging material can be recy-
cled. Please do not place the packag-
ing into the ordinary refuse for dispos-
al, but arrange for the proper recy-
cling.
Old appliances contain valuable ma-
terials that can be recycled. Please
arrange for the proper recycling of old
appliances. Batteries and accumula-
tors contain substances that must not
enter the environment. Please dis-
pose of your old appliances, batteries
and accumulators using appropriate
collection systems.
Notes about the ingredients (REACH)
You will find current information about the
ingredients at:
www.kaercher.com/REACH
20

Before Startup

– Check the contents of the pack before
unpacking.
– In case of transport damage inform ven-
dor immediately.
 The oil level must be at the centre of the
oil level display.
Activate deaeration of oil container
 Unscrew the screw plug.
 Screw in enclosed oil filling screw.
 Close cover.
Attaching the Accessories
 Connect spray lance to trigger gun.
 Install nozzle with nozzle screw at the
spray lance.
 Screw the high-pressure hose on to the
hand spray gun.
 Fasten the high pressure hose to the
high pressure connection.
Mounting the cable / hose rack
 If required, attach accompanying cable
/ hose rack to the wall.
or
Illustration
 Attach the enclosed cable/hose rack to
the bottom of the device.
Attaching the holder for the trigger
Note:
Not all unit models are equipped with the
holder for the trigger gun.
Illustration
 Attaching the support.
– 5
EN
Unpacking
Check oil level
gun