Instructions; Usage Without Wifi Connection; Child Lock - Mill OIL2000WIFI3 Montageanleitung

6
While in open window mode, it will maintain 5°C (to avoid frost damage).
The heater will automatically start heating again if temperature increase by at least
3 degrees within 15 minutes.
You can switch the heater back to normal mode by pressing the settings button 1 time.
Open window function can be disabled/enabled by pressing and holding the settings
button for 3 seconds. You can also disable/enable open windows function from the app
if configured to WiFi.
The heater will stay in open window mode for maximum 1 hour, it then will go back
to normal heating mode.

Instructions

Control panel
1. Thermostat and WiFi button
A
2. Settings button
3. ON/OFF button
WARNING!
INSTRUCTIONS BEFORE USING THE HEATER!

Usage without WiFi connection

1. Plug the heater into a grounded outlet.
2. Press the ON/OFF button.
3. Turn the thermostat to the desired temperature while looking at the display. As soon
as the room temperature drops below this level, the heater will automatically start
again. When the room has reached the desired temperature again, the heater will
4. The thermostat goes from 5 to 35°C.
5. If you want to change the temperature in the room, repeat step 3.
6.
become extremely hot.
7.
for a longer period, pull out the plug.

Child lock

You can enable/disable child lock from the app. But in addition, you can also
enable/disable child lock from the heater itself. Turn o the heater using the main
power switch. Turn the heater back on, within 5 seconds press the and hold
BE SURE THE FOOT IS FITTED CORRECTLY AND ACCORDING TO THE
1. Power indicator – shows whether the
B
heater is using power or not
2. ON/OFF indicator
3. WiFi indicator
4. Desired room temperature
5. Thermostat and WiFi button
.