Instructions; Usage Without Wifi Connection - Mill Gentle Air WiFi-Serie Bedienungsanleitung

6
The heater will automatically start heating again if temperature increase by
at least 3 degrees within 15 minutes.
You can switch the heater back to normal mode by pressing the settings button 1 time.
Open window function can be disabled/enabled by pressing and holding the settings
button for 3 seconds. You can also disable/enable open windows function from the app
if configured to WiFi.
The heater will stay in open window mode for maximum 1 hour, it then will go back to
normal heating mode.

Instructions

Control panel
1. Standby
2. Control light WiFi
3. Power indicator - shows whether the heater is using power or not
4. Desired room temperature
5,6,7 Indicates the output level
8. Timer function indicator
9. Output selector – push the button to change the desired power level. 3 power
levels.
10. WiFi button
11. Settings button
12. Timer activation button
13.
turn the selector to the right to increase the temperature
WARNING!
INSTRUCTIONS BEFORE USING THE HEATER!

Usage without WiFi connection

1. Plug the heater into a grounded outlet.
2. Press OFF/ON button.
3. Choose the desired power |, || or |||, by pressing the output selector. Turn the
thermostat to the desired temperature while looking at the display. As soon as the
room temperature drops below this level, the heater will automatically start again.
When the room has reached the desired temperature again, the heater will turn itself
off.
4. The thermostat goes from 5 to 35°C.
5. If you want to change the temperature in the room, repeat step 3.
6. The heater has an overheat protection that turns the device off if any parts become
extremely hot.
7. To turn off the heater, press the OFF/ON button. Should the heater be left unused
for a longer period of time, pull out the plug.
BE SURE THE FOOT IS FITTED CORRECTLY AND ACCORDING TO THE
Usage without WiFi connection
rature, and