Instructions Mechanical Thermostat; Usage Mechanical Thermostat - Mill SG2000MEC Bedienungsanleitung

6 millnorway.com
B
Electronic Thermostat
1. Remove the pre-mounted screws on both legs before you insert them into thebrack-
ets, so that you get a stable foot.
2. Attach the legs to the brackets by tightening 2 screws into each bracket.
3. Remove the pre-mounted screws from the bottom of the heater and place the heater
gently on its head to mount the feet.
4. Two screws must be fastened on each foot bracket.
5. NEVER USE THE HEATER BEFORE THE LEGS HAVE BEEN TIGHTLY SCREWED.

Instructions mechanical thermostat

Please see table on page 4 for which models that have mechanical thermostats
Control Panel
See figure 4 on separate illustration sheet
1. Thermostat: Adjust the desired heat settin
A
2. Output selector:
0: OFF
|: 750W
||: 1250W
|||: 2000W
WARNING:
INSTRUCTIONS BEFORE USING THE HEATER!
ATTENTION!
must not be used without supervision

Usage mechanical thermostat

1. Set the output selector to the OFF position (0) and the thermostat to minimum. Plug
the heater into a grounded outlet.
2. Set the output selector to position |, || or |||. Turn the thermostat up to the maximum
position. When the desired room temperature has been reached, turn the thermostat
slowly down until you hear a click. The thermostat can now remain in this position
until a different room temperature is desired. As soon as the room emperature falls
below this level, the heater will automatically switch on again. When the room has
again reached the desired temperature, the heater will switch off again.
3. If you wish to change the room temperature, repeat the instructions in step 2.
4. The heater has an overheat protection that turns the device off if any parts become
extremely hot.
5. To switch the heater off, turn the output selector to the O position. If the heater will
be left unused for a longer period of time, pull out the plug.
SG2000MEC
BE SURE THE FOOT IS FITTED CORRECTLY AND ACCORDING TO THE
This heater is only meant to be used as a supplementary heating source, and
B
CO2200MECMAX
0: OFF
|: 1000W
||: 1200W
|||: 2200W