Hacker HST-70 Betriebsanleitung Seite 33

Mounting and commissioning
The drive is operated under „Control". If the check mark is set at „Enable", the con-
trol via the GUI is active. Remove the check mark to ensure that the drive does not
start up accidentally due to incorrect input.
The slider can be operated with the mouse or very sensitively with the keyboard.
If you want to control the slider with the keyboard, either click with the mouse in its
area, or press the TAB key on your keyboard until the slider is framed with black
dots. Use the „left" and „up" arrow keys to increase the power, and the „right" and
„down" arrow keys to decrease the power.
Below the slider you will find an input field in which you enter the value of the desi-
red slider position in percent. Only when you confirm with [Set], the entered value is passed on to
the slider. With a click on [<0>] you stop the motor without delay.
Graph
Click on the [Graph] button to display the read-out values graphically in real time. The drive can
also be controlled while you have this view open. If you want to record/document certain situati-
ons, you can make a screenshot of it (press the [Print] key on the keyboard, then paste the image
in a graphics program [CTRL+V]).
Brushless DC Controller HST-70 Page 33 of 38
Orginal operating manual Rev1.2