Hacker HST-70 Betriebsanleitung Seite 35

Mounting and commissioning
Settings – Motor
Here you set the parameters to optimally adjust the controller to the hardware of your drive.
Motor settings:
Advance: Enter the advance angle here.
Pole pair: Enter the number of pole pairs here.
Control settings:
Select the type of control here.
Limits:
Enter limits here according to the function in order not to overload the drive.
Settings – Regulators
Under RPM reg. settings and Current reg. settings you set the PID values (Proportional-Integral-
Derivative controller) of the controller. This allows you to optimize the running of the motor.
Brushless DC Controller HST-70 Page 35 of 38
Orginal operating manual Rev1.2