Troubleshooting - Electrolux KODGS20TX Benutzerinformation

The screen-printing zone must face the inner side of
the door. Make sure that after the installation the sur‐
face of the glass panel frame on the screen-printing
zones is not rough when you touch it.
When installed correctly the door trim clicks.
Make sure that you install the internal glass panel in
the seats correctly.
12.6 How to replace: Lamp
WARNING!
Risk of electric shock.
The lamp can be hot.
Step 1
Turn off the oven. Wait until the
oven is cold.
Back lamp
Step 1 Turn the glass cover to remove it.
Step 2 Clean the glass cover.
Step 3 Replace the lamp with a suitable 300 °C heat-resistant lamp.
Step 4 Install the glass cover.

13. TROUBLESHOOTING

WARNING!
Refer to Safety chapters.
13.1 What to do if...
In any cases not included in this table please
contact with an Authorised Service Centre.
Problem
The oven does not heat
up.
The door gasket is dam‐
aged.
20 ENGLISH
Before you replace the lamp:
Disconnect the oven from the
Check if...
The fuse is blown.
Do not use the oven.
Contact an Authorised
Service Centre.
Always hold the halogen lamp with a cloth to
prevent grease residue from burning on the
lamp.
Step 2
Put a cloth on the bottom of the cav‐
mains.
Problem
The display shows
"12.00".
The water leaks out of
the cavity embossment.
Unsatisfying cooking per‐
formance of the function:
True Fan Cooking
PLUS .
The lamp does not work.
A
Step 3
ity.
Check if...
There was a power cut.
Set the time of day.
There is too much water
in the cavity emboss‐
ment.
You filled the cavity em‐
bossment with water.
The lamp is burnt out.