Connection To Power Mains - Elektra Beckum PK 300 K Betriebs- Und Montageanleitung

Loosely attach 2 carriage bolts M 6x16 to hose carrier, then slide hose carrier into the
rear T-groove of the table.
Install spiral hose between saw blade guard and dust collection port.
3.1 Rip Fence Scale Adjustment
The rip fence scale is adjustable to accommodate saw blades of different widths.
Set rip fence against the blade. Loosen scale fixing screw and set scale until zero
mark matches the hairline of the fence bracket's magnifying glass. Tighten fixing
screw and verify setting by making a trial cut on a piece of scrap.
Note: The scale's zero mark and the hairline of the magnifying glass can only
line up with the fence extrusion installed in the upright position (wide edge facing
the blade).
3.2 Magnifying Class
The magnifying glass can be removed
from the rip fence for cleaning.
4

Connection to Power Mains

- This machine must be operated on a residual current operated device of 30 mA capacity, having a fault current breaker.
- This machine must be safety earthed. The yellow/green lead is the earth conductor.
- Fit plug matching your local standard outlet to the power cable.
- The outlet this machine is connected to must be earthed and phase protected by a 16 A time-lag fuse or circuit breaker.
- Do not operate saw with a damaged power cable. Risk of electrical shock.
Worn or defective cables must be replaced immediately. Have replaced by a qualified electrician only.
Check if voltage of power mains matches with voltage stated on machine's type plate.
For mains connection a 5-lead power cable is required. The yellow/green lead is the earth conductor. Do not connect the
yellow/green earth lead to any of the current conducting terminals. If in doubt-consult a qualified electrician.
Extension cables should have a minimum lead cross section of 1.5 mm
Use of extension cables with too small a lead cross section causes a voltage drop and possible damage to motor and/or switch.
Important! Always disconnect from power before servicing the saw.
Direction of rotation of the saw blade is clockwise, when looking at it from the left side of the saw. To check start saw briefly.
If the blade runs counter-clockwise on a three-phase machine, have a qualified electrician interchange two of the phases to
correct.
Note: Wrong direction of rotation of the saw blade is dangerous and may cause severe personal injury.
3.3 Rip Fence Adjustment
The rip fence is factory set parallel with the
saw blade. If adjustment is necessary
loosen the four screws holding the fence
extrusion to the carrier and set square
with the table.
18
Raise saw blade (see paragraph 5) and
attach saw blade guard to riving knife.
3.4 Mitre Fence Adjustments
Both left and right hand 45° end stops are
factory set. If required the positions can
be adjusted with the setting screws. The
angle scale is also adjustable.
2 and a rubber outer jacket (HO7RNF/SJT or similar).