Parkside PFLA 4400 A1 Bedienungs- Und Sicherheitshinweise Seite 11

Never immerse the product in water or other liquids!
Only connect the product to a properly installed USB socket . The
voltage must comply with information given in the section "Technical
data" .
Do not carry out any modifications or repairs to the product yourself .
The LEDs cannot and must not be replaced .
The LEDs are not replaceable .
If the LEDs fail at the end of their lives, the entire product must be
replaced .
m CAUTION! DANGER OF BURN INJURIES! To prevent burns,
verify the product is switched off and has cooled down for at least
15 minutes before touching it . The product can become very hot .
The accessible surface, especially heat shrink, is very hot when the lamp
is operating .
FIRE HAZARD! Fit the product so that it is at least 0 .1 metre
away from the material to be illuminated . Excessive heat can result
in a fire .
WARNING!
facing down to a combustible surface . The exposed surface may be
overheated or ignited .
Do not place burning candles or open fire on or near the product .
Do not use the product near heat sources such as radiators or devices
emitting heat .
Dispose of the product if product or USB cable
Ensure the USB cable
hot objects . Unwind the USB cable completely before use .
10 GB/IE/NI
Do not turn on the light when the product is
cannot become damaged by sharp edges or
10 ] [
are damaged .
10 ] [