Installation And Configuration; Point Source - dB Technologies IS26T Bedienungsanleitung

3. INSTALLATION AND CONFIGURATION

The section gives some example installations suggesting various applications of both of the waveguide and the
point source models. Also consult the instructions for the accessories, as well as any prescriptions reported on the
product labels.
CAUTION!
Only expert personnel may use the product and its accessories! To prevent hazards to people,
animals and/or objects, make sure that the installation is stable and secure. Comply with the
safety regulations and laws in force in the country in which you use the product. For safe use,
periodically check that all parts are in good working condition before use. Only authorised
personnel may carry out design, calculations, installation, testing and maintenance of
professional flown or stacked audio systems. AEB Industriale shall not be liable for improper
installation carried out without adequate safety measures.

3.1. POINT SOURCE

The IS26T can be used and installed in a wide variety of
configurations thanks to an extensive range of accessories.
This makes for outstanding versatility, as does the possibility to
convert a point source model into a line array model and vice
versa, and to rotate the horn, as shown in the following pages.
For further information and for all the safety prescriptions, refer
to the relevant instructions and product labels.
IS26T
20
0° -10°
Support for pole mounting
SA-2X6
Cod. 420120377 REV. 1.1
English