Wedge (Monitoring) Use; Wall-Mounting With Brackets; Installation On Truss With Brackets And Aliscaff Couplers; Installation With Eyebolts - dB Technologies OPERA UNICA 12 Bedienungsanleitung

English

WEDGE (MONITORING) USE

The OPERA UNICA series speakers can be used as monitors for small live contests. In
this case, lay them horizontally on the tilted side. Be reminded of the sound coverage
features reported in the relevant section. Use the suitable DSP settings as indicated in
the "DSP preset" table in wedge mode (W1 or FLAT).

WALL-MOUNTING WITH BRACKETS

The OPERA UNICA models can be wall-mounted in vertical or horizontal position
through the WB-OP12, WB-OP15 accessory, to be used with OPERA UNICA 12 and
OPERA UNICA 15, respectively.
For further details refer to the instructions relevant to this accessory.

INSTALLATION ON TRUSS WITH BRACKETS AND ALISCAFF COUPLERS

The OPERA UNICA models can be installed on a truss in vertical or horizontal
position, through the WB-OP12, WB-OP15 accessory, to be used with OPERA UNICA
12 and OPERA UNICA 15, respectively. This accessory allows the use of aliscaff
couplers (not included) for this special configuration.
For further details refer to the instructions relevant to this accessory.

INSTALLATION WITH EYEBOLTS

The speaker can also be installed using eyebolts.
The positioning is shown in the figure on the side,
where the rear eyebolt allows adjusting the final
angle (MAX 45°).
OPERA UNICA 12 - OPERA UNICA 15 Cod. 420120269 REV. 1.0
31