Maintenance - Husqvarna FS 600 E Bedienungsanweisung

To operate the light kit
The light kit is an accessory. Only use the 24 V outlet for
the working light for Husqvarna approved light kits.
WARNING:
1. Install the light kit to the 24 V outlet for the working
light.
Introduction
WARNING:
safety chapter before you do maintenance
on the product.
For all servicing and repair work on the product, special
training is necessary. We guarantee that professional
repairs and servicing is available. If your dealer is not a
service agent, speak to them for information about the
nearest service agent.
For spare parts, speak to your Husqvarna dealer or
service agent.
To do before the maintenance
• Park the product on a level surface and stop
the motor. Push the machine stop button on the
control panel to prevent accidental start during

maintenance.

1620 - 004 -
Do not look into the beam.
Maintenance
Read and understand the
2. Push the light switch to make the light kit come on.
3. Push the light switch again to make the light kit go
off.
• Make sure that the product cannot move during
maintenance. Engage the parking brakes and put
wheel chocks behind and front of the wheels.
• Always pull out the plug from the mains outlet before
you clean, do maintenance or assemble the product.
• Clean the area around the product from oil and dirt.
Remove unwanted objects.
• Put clear signs around the maintenance area to give
a warning to bystanders that maintenance work is in
progress.
• Keep fire extinguishers, medical supplies and an
emergency phone near.
21