Water Connection - Miele PFD 104 SCVi Installationsplan

Water connection

Water inlet
The dishwasher must only be connected to fully vented pipework.
A brief increase in the water pressure can damage components of
the dishwasher.
The quality of the incoming water must correspond to the drinking
water specification of the country in which the dishwasher is being
operated.
The dishwasher must be connected to the water supply in strict ac-
cordance with current local and national water authority regulations. It
can be connected to cold or hot water supplies. Connecting the dish-
washer to a hot water supply will reduce programme running times.
For short programme running times, a water pressure of at least
200 kPa is also required.
Regulation in Germany:
For the protection of drinking water, the non-return device supplied
with the dishwasher must be installed between the stopcock and the
water inlet hose.
Screw a non-return device onto the stopcock. Then screw the water
inlet hose with the water protection system onto the thread of the
non-return device.
If a stopcock is not available, only a qualified installer may connect
the dishwasher to the drinking water supply.
The stopcock should remain accessible once the dishwasher has
been installed so that the water supply can be shut off whenever the
appliance is not in use.
en - Installation notes
15