Water Connection - Miele PFD 400 Installationsplan

Water connection

Water inlet
The dishwasher must only be connected to fully vented pipework.
A brief increase in the water pressure can damage components of
the dishwasher.
Regulations in Germany and Switzerland
In line with national provisions relating to the protection of drinking
water, the non-return valves supplied for the cold and hot water sup-
plies must be must be installed between the stopcock and the water
inlet hose.
Screw a non-return valve onto the stopcock on site. Then screw the
water inlet hose with the water protection system onto the thread of
the non-return valve.
The quality of the incoming water must correspond to the drinking
water specification of the country in which the dishwasher is being
operated.
The dishwasher must be connected to the water supply in strict ac-
cordance with current local and national water authority regulations.
The dishwasher can be connected to cold or hot water
hot water is not available, the two water inlet hoses (for cold and hot
water) must be connected to the cold water supply via a Y-piece. The
Y-piece must be connected after the non-return valve.
The stopcocks should remain accessible once the dishwasher has
been installed so that the water supply can be shut off whenever the
appliance is not in use.
1) PFD 400: connection to cold or hot water with a water inlet hose
en - Installation notes
1)
supplies. If
19