Technical Data; Scope Of Delivery; Safety Instructions - Parkside PSHL 2 B1 Bedienungs- Und Sicherheitshinweise

12 Sensitivity setting
13 Delay setting
14
LED Lighting switch
15
Battery compartment
16 Bracket
17 Arc sensor
18
LED
19
Battery

Technical Data

z z
Filter cartridge size:
Field of vision:
Bright state:
Dark state:
Switching times
Bright to dark:
Dark to bright:
Switch on / off:
Energy supply:
UV / IR protection:
Operating temperature: -5 °C to +55 °C
Storage temperature:
Welding procedure:
Maximum service life: approx. 6 years

Scope of delivery

z z
1 Auto-Darkening Welding Helmet
1 Set of instructions for use

Safety instructions

Please carefully read the
instructions for use and follow
the specified notices. Familiarise
yourself with the equipment, its
proper use and the safety notices
using these instructions for use.
110 x 90 x 9 mm
9.2 x 4.2 cm
DIN 4
DIN 9–DIN 13
0.23~0.72 ms
0.1~2 s
Fully automatic
Solar cell
DIN 16
-20 °C to + 70 °C
MMA, MIG, MAG,
TIG, plasma cutting
and plasma welding
Introduction/ Safety instructions
All technical data about this
welding helmet is on the label,
please learn about this product's
technical facts.
The product is not suitable for
„ z
laser welding.
The product is only approved
„ z
for use within a temperature
range of between -5 °C to 55
°C.
The product is not fire-resistant.
„ z
Welding helmet and ADF filter
„ z
must not be exposed to any
heat or moisture.
Do not remove the ADF filter
„ z
from the welding helmet and
never open the housing of the
ADF filter without authorisation
from the manufacturer.
Prior to each use, check wheth-
„ z
er the Welding/Grinding set-
ting was selected correctly.
The cover lens must be in-
„ z
stalled on the outer side of the
ADF filter. Otherwise, the ADF
filter can get damaged.
Do not carry out any
„ z
modifications/replacements on
the welding helmet and ADF
filter without consent.
If the filter does not darken
„ z
automatically whilst weld-
ing please stop the operation
immediately and contact the
dealers without delay.
GB 7