Recess dimensions
820 mm
580 mm
1. Remove cardboard, polystyrene and ad-
hesive strips from the inside of the dish-
washer, if you have not already done so.
2. Loosen both screws on the reverse side
of the covering panel and remove them.
Installation, connection and initial commissioning
90°
Inlet/outlet area and
electrical connection.
600 mm
90°
80 mm
100 mm
(37)
3. Affix the enclosed condensation protec-
tion film (37) to the underside of the work-
top. In this way, you will avoid damage to
the worktop caused by hot steam emitted
from the dishwasher when the appliance
door is left open.
4. Place the dishwasher in the desired po-
sition.
Page EN-33