Make A Call - Kenwood KMM-BT408DAB Bedienungsanleitung

Bluetooth®
While having two active calls...
End current call and activate
held call
Swap between the current call
and held call
Adjust the phone volume*1
[00] to [35] (Default: [15])
Switch between hands-free and
private talk modes*2
*1 This adjustment will not affect the volume of the other sources.
*2 Operations may vary according to the connected Bluetooth device.
Improve the voice quality
While talking on the phone...
1 Press the volume knob to enter [FUNCTION].
2
Turn the volume knob to select an item (see the following table), then
press the knob.
3
Repeat step 2 until the desired item is selected/activated.
4
Press and hold to exit.
To return to the previous setting item, press
[MIC GAIN] [–10] to [+10] ([–4]): The sensitivity of the microphone increases as the
number increases.
[NR LEVEL] [LEVEL –5] to [LEVEL +5] ([LEVEL 0]): Adjust the noise reduction level
until the least noise is being heard during a phone conversation.
[ECHO CANCEL] [LEVEL –5] to [LEVEL +5] ([LEVEL 0]): Adjust the echo cancellation
delay time until the least echo is being heard during a phone conversation.
• Call quality may depend on mobile phone.
Press .
Press .
Turn the volume knob during a call.
Press 6 IW during a call.
.
Default: [XX]
Make the setting for answering a call
1
Press to enter Bluetooth mode.
2 Turn the volume knob to select [SETTINGS], then press the knob.
3 Turn the volume knob to select [AUTO ANSWER], then press the knob.
4 Turn the volume knob to select the time (in seconds) for the unit to
answer the call automatically, then press the knob.
[01] to [30], or select [OFF] to cancels. (Default: [OFF])
5
Press and hold to exit.
To return to the previous setting item, press

Make a call

You can make a call from the call history, phonebook, or dialing the number.
Call by voice is also possible if your mobile phone has the feature.
1
Press to enter Bluetooth mode.
"(First device name)" appears.
• If two Bluetooth phones are connected, press
other phone.
"(Second device name)" appears.
2
Turn the volume knob to select an item (see the following table), then
press the knob.
3
Repeat step 2 until the desired item is selected/activated or follow the
instructions stated on the selected item.
4
Press and hold to exit.
To return to the previous setting item, press
[CALL HISTORY] (Applicable only if the phone supports PBAP.)
1 Press the volume knob to select a name or a phone number.
• "I" indicates call received, "O" indicates call made, "M" indicates call
missed.
• Press DISP to change the display category (NUMBER or NAME).
• "NO DATA" appears if there is no recorded call history or call number.
.
again to switch to the
.
15
ENGLISH