Kenwood KMM-BT408DAB Bedienungsanleitung Seite 35

Installation/Connection
Connect external components
No Part
1 Microphone input jack (Page 13)
2 Output terminals (See the following "Connect external amplifiers via output terminals".)
3
DAB antenna jack (Page 7, 30)
Connect external amplifiers via output terminals
When connecting an external amplifier to the output terminals of this unit,
securely connect the amplifier ground wire to the car chassis to prevent
damage to the unit.
Output terminals 2-way crossover
REAR/SW: Rear/subwoofer output
Installing the DAB antenna
Connect the supplied DAB antenna to the DAB antenna jack. (See the left
column.)
For details, see the following.
• The film antenna (F) is exclusively for use inside the vehicle.
• Do not install at the following locations:
– where it may block the driver's view.
– where it may obstruct the operation of safety devices such as air bags.
– on movable glass surfaces such as the rear hatch.
– at side of vehicle (e.g. door, front quarter window).
– on rear window.
• Signal strength will weaken when installed at the following locations:
– on IR reflecting glass or locations covered with mirror type glass film.
– where it overlaps with genuine radio antenna (pattern).
– where it overlaps with window heating wires.
– on glass that blocks radio signals (e.g. IR reflecting glass, thermal
• Poor reception may occur:
– due to noise when windscreen wiper, air conditioner, or motor is turned
– depending on the direction of the broadcast station with respect to the
3-way crossover
• Thoroughly wipe oil and dirt from the pasting surface with the supplied
Woofer output
cleaner (I).
• Do not bend or damage the film antenna (F).
• It may not be possible to install on certain vehicles.
• Check the cable routing of the film antenna (F) and amplifier unit (G)
before pasting.
• Do not apply any glass cleaner after pasting the film antenna (F).
CAUTION
insulation glass).
on.
vehicle (antenna).
27
ENGLISH