Safety Notes; Installation Instructions; Technical Data; Symbol Description - HANSGROHE Metris S 31160000 Gebrauchsanleitung, Montageanleitung

Safety Notes

Gloves should be worn during installation to prevent
crushing and cutting injuries.
The product may only be used for bathing, hygienic
and body cleaning purposes.
The hot and cold supplies must be of equal
pressures.

Installation Instructions

• Prior to installation, inspect the product for transport
damages. After it has been installed, no transport or
surface damage will be honoured.
• The pipes and the fixture must be installed, flushed
and tested as per the applicable standards.
• The plumbing codes applicable in the respective
countries must be observed.
• 31285000 / 31927000 / 32522000 /
74522000 / 76210XXX / 76220XXX: The drain
valve must only be used as intended. It is not allowed
to attach other objects to the drain valve, for
example a semi-pedestal.

Technical Data

Operating pressure:
Recommended operating pressure:
Test pressure:
Hot water temperature:
Thermal disinfection:
The product is exclusively designed for drinking water!

Symbol description

Do not use silicone containing acetic acid!
Adjustment (see page 35)
To adjust the hot water limiter. Using a hot water limiter
in combination with a continuous flow water heater is
not recommended.
Dimensions (see page 38)
Flow diagram (see page 41)
Spare parts (see page 42)
XXX = Colors
000 = Chrome Plated
670 = Matt Black
Special accessories (order as an extra)
seal #98996000 (see page 33)
4
max. 1 MPa
0,1 - 0,5 MPa
1,6 MPa
(1 MPa = 10 bar = 147 PSI)
max. 60°C
70°C / 4 min
Assembly (see page 32)
English
Cleaning (see page 49)
Operation (see page 37)
• Hansgrohe recommends not to use as drinking water
the first half liter of water drawn in the morning or
after a prolonged period of non-use.
• Due to the design of the Bidette fittings, a small
amount of water will leak at the outlet of the fitting
when the hand shower is running.
Test certificate (see page 52)