Safety Notes; Installation Instructions; Technical Data; Flow Diagram - HANSGROHE Talis S2 32047000 Gebrauchsanleitung, Montageanleitung



Safety Notes

Gloves should be worn during installation to prevent

crushing and cutting injuries.
The shower system may only be used for bathing,

hygienic and body cleansing purposes.
The hot and cold supplies must be of equal pres-

sures.

Installation Instructions

• The fitting must be installed, flushed and tested after
the valid norms.
• Hansgrohe mixers can be used together with hydrau-
lically and thermically controlled continuous flow
heaters if the flow pressure is at least 0,15 MPa.
• If the instantaneous water heater causes problems or
if you wish to increase the water flow, the EcoSmart®
(flow limiter) located behind the aerator can be
removed.

Technical Data

This mixer series-produced with EcoSmart®
(flow limiter)
Operating pressure:
Recommended operating pressure:
Test pressure:
(1 MPa = 10 bar = 147 PSI)
Hot water temperature:
Recommended hot water temp.:
Fault
Insufficient water
Mixer stiff
Mixer dripping
Hot water temperature too low

English
Symbol description
max. 1 MPa
0,1 – 0,5 MPa
1,6 MPa
max. 80°C
65°C
Cause
- Aerator calcified, dirty
- Cartridge defective, calcified
- Cartridge defective
- Hot water limiter incorrectly set
Assembly see page 32
Adjustment
To adjust the hot water limiter on single lever
mixers, please see page 31. No adjustment
is necessary when using a continuous flow
water heater.
Do not use silicone containing acetic acid!
Dimensions (see page 34)

Flow diagram

(see page 34)

with EcoSmart®

without EcoSmart®
Spare parts (see page 35)
Operation (see page 36)
Cleaning (see enclosed brochure.
Remedy
- Clean aerator, replace as
necessary
- Exchange cartridge
- Exchange cartridge
- Set hot water limiter
)