Selecting The Correct Rotational Speed And Sanding Belt - Parkside PBS 600 A1 Bedienungs- Und Sicherheitshinweise Originalbetriebsanleitung

To switch off continuous operation mode:
P ress and then release the on / oFF switch
Selecting the correct rotational
Q
speed and sanding belt
You can select the belt speed using the belt speed
adjuster wheel even whilst the sander is running.
1
The optimum belt speed depends on the workpiece
and the workpiece material. Always confirm the best
speed by carrying out a small test. The following
table lists some recommended values to help you
determine the optimum speed.
Material / type of
work
Coarse finish
(Grit grade)
Fine finish (Grit grade) 240
Preselected rotation
speed
Material / type of
work
Coarse finish
(Grit grade)
Fine finish (Grit grade) 180
Preselected rotation
speed
Material / type of
work
Coarse finish
(Grit grade)
Fine finish (Grit grade) 150
Preselected rotation
speed
All manuals and user guides at all-guides.com
3
.
Softwood
60
high (5-6)
Hardwood
60
high (5-6)
Chipboard
60
high (5-6)
Material / type of Removing paint /
work varnish
Coarse finish 60
(Grit grade)
Fine finish (Grit grade) ––
Preselected rotation high (5-6)
speed
Material / type of Sanding varnish
work
Coarse finish 150
(Grit grade)
Fine finish (Grit grade) 320
Preselected rotation low (1-2)
speed
Material / type of Rust removal
work
Coarse finish 40
(Grit grade)
Fine finish (Grit grade) 120
Preselected rotation medium / high (3-4)
speed
Material / type of Plastic
work
Coarse finish 120
(Grit grade)
Fine finish (Grit grade) 240
Preselected rotation low / medium (2-3)
speed
Material / type of Non-ferrous metals
work (e.g. aluminium)
Coarse finish 80
(Grit grade)
Fine finish (Grit grade) 150
Preselected rotation medium / high (3-4)
speed
operation
GB/MT 41