Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
KB 200
Bedienungsanleitung / Operating instructions / Mode d'emploi
Before starting up or setting the machine in motion, make sure that nobody is at risk. Keep children
and unauthorized persons away from the work area! The machine is designed for use in daylight! The
machine operator/ owner must ensure sufficient workplace lighting for non-illuminated work sites!
Always keep at a distance from the edges of building pits and slopes. Avoid any operation that might
be a risk to machine stability. Keep the work area clean. Cluttered areas and benches invite injuries!
Do not operate when you are tired! Watch what You are doing! Control the working area for water-,
gas- and electrical lines!
During work
Make sure, that the drill rig is well fastened before and while drilling! Never touch rotating parts like
drill spindle or drill bit!
After work
Before leaving the machine always secure it against unauthorized use!
1.5
Special work related to the maintenance and repair of the machine
Observe the adjustment, maintenance and inspection activities and intervals set out in the operating
manual, including information on the replacement of parts or assemblies! These activities may be
performed by skilled personnel only. Brief the operating personnel before initiating special repair or
maintenance activities. Appoint a person to supervise such activities.
In any work concerning the operation, conversion or adjustment of the machine and it's safety-oriented
devices or any work related to inspection, maintenance and repair, always observe the start-up and
shut-down procedures described in the operating manual and the information on maintenance work.
Carry out maintenance and repair work only of the machine is positioned on stable and level ground
and has been secured against inadvertent movement and buckling.
If the machine is completely shut down for maintenance and repair work, it must be secured against
inadvertent starting.
To avoid the risk of accidents, individual parts and large assemblies being moved for replacement
purposes should be carefully attached to lifting tackle and secured. Use only suitable and technically
perfect lifting gear and suspension systems with adequate lifting capacity. Never work or stand under
suspended loads.
The fastening of loads and the instructing of crane operators should be entrusted to experienced
persons only. The marshaller giving the instructions must be within sight or sound of the operator.
For carrying out overhead assembly work always use specially designed or otherwise safety-oriented
ladders and working platforms. Never use machine parts as a climbing aid. Wear safety harness when
carrying out maintenance work at greater heights. Keep all handles, steps, handrails, platforms,
landings and ladders free from dirt.
Clean the machine, especially connections and threaded unions, of any traces of oil, fuel or
preservatives before carrying out maintenance/ repair. Never use aggressive detergents. Use lint-free
cleaning rags. Before cleaning the machine with water, steam jet or detergents, cover or tape up all
openings which -for safety and functional reasons - must be protected against water, steam or
detergent penetration. After cleaning, remove all covers and tapes applied for that purpose.
Always tighten any screwed connections that have been loosened during maintenance and repair.
Any safety devices removed for set-up, maintenance or repair purposes must be refitted and checked
immediately upon completion of the maintenance and repair work.
Ensure that all consumables and replaced parts are disposed of safely and with minimum
environmental impact.
1.6
Oils, greases and other chemical substances
When handling lubricating fluids, greases or preservatives (called operating materials and lubricants in
the following), the safety regulations applicable for the respective product must be observed!
All manuals and user guides at all-guides.com
- 18-
02952000996
5005984-01
Werbung
Inhaltsverzeichnis
Fehlerbehebung
