Intended Use; Organizational Measures - GÖLZ KB 200 Bedienungsanleitung

KB 200
Bedienungsanleitung / Operating instructions / Mode d'emploi
1.1

Intended use

The machine has been built in accordance with state-of-the-art standards and the recognized safety
rules. Nevertheless, its use may constitute a risk to life and limb of the user or of third parties, or cause
damage to the machine and to other material property.
The machine must only be used in technical perfect condition in accordance with its designated use
and the instructions set out in the operating manual, and only by safety-conscious persons who are
fully aware of the risks involved in operating the machine. Any functional disorders, especially those
affecting the safety of the machine, should therefore be rectified immediately!
The machine is designed exclusively for drilling in concrete, reinforced concrete, natural stone, cast
stone and brickwork. Using the machine for purposes other than mentioned above (such as drilling in
wood and so on) is considered contrary to its designated use. The Gölz GmbH cannot be held liable
for any damage resulting from such use. The risk of such misuse lies entirely with the user.
Only use gear drives and motors, that are provided by Gölz GmbH. Also attend those operating
manuals.
Operating the machine within the limits of its designated use also involves observing the instructions
set out in the operating manual and complying with the inspection and maintenance directives
1.2

Organizational measures

This operating manual must always be at hand at the place of use of the machine and must be
accessible to the person operating the machine!
In addition to this operating manual, observe and instruct all other generally applicable legal and other
mandatory regulations relevant to accident prevention and environmental protection.
These compulsory regulations may also deal with the handling of hazardous substances, issuing and/
or wearing of personal protective equipment, or traffic regulations.
This operating manual must be supplemented by instructions covering the duties involved in
supervising and notifying special organizational features, such as job organization, working sequences
or the personnel entrusted with the work.
Person entrusted with work on the machine must have read the operating manual before beginning
work. This applies especially to persons working only occasionally on the machine, e.g. during setting
up or maintenance activities.
Check - at least from time to time - whether the personnel is carrying out the work in compliance with
the operating manual and paying attention to risks and safety-relevant factors.
Observe all safety precautions and warnings attached to the machine. See to it that safety instructions
and warnings attached to the machine are always complete and perfectly legible.
In the event of safety-relevant modifications or changes in the behaviour of the machine during
operation, stop the machine immediately and report the malfunction to the competent authority/
person.
Never make any modifications, additions or conversions which might affect safety without the Gölz
GmbH's approval. This also applies to the installation and adjustment of safety devices as well as to
welding and drilling work on supporting structures.
Damaged or worn parts of the machine must be replaced immediately. Use genuine spare parts only.
All spare parts and tools must comply with the technical requirements specified by the Gölz GmbH. All
maintenance and repair activities must be performed by qualified personnel using suitable tools and
other suitable workshop equipment.
Adhere to the legally prescribed preventive maintenance and inspection intervals or those specified in
this operating manual!
Observe the fire alarm and fire fighting measures. The personnel must be made familiar with the
location and handling of fire extinguishers!
Personal protection equipment
For reasons of safety, long hair must be tied back or otherwise secured, garments must be close-
fitting and no jewellery - including rings - may be worn. Severe injury may result from being caught by
moving parts of the machine.
All manuals and user guides at all-guides.com
- 16-
02952000996
5005984-01