Kärcher K 7.20 MX Betriebsanleitung Seite 17

Operation
Scope of delivery
The scope of delivery of your appliance is il-
lustrated on the packaging. Check the con-
tents of the appliance for completeness
when unpacking.
In the event of missing accessories or any
transport damage, please contact your
dealer.
Description of the Appliance
These operating instructions describe the
maximum equipment. Depending on the
model, there are differences in the scopes
of delivery (see packaging).
Illustrations on fold-out page!
1 Quick coupling for high pres-
sure hose
2 High pressure connection
3 Coupling element for water connection
4 Connection for water supply with filter
5 Appliance switch "0/OFF"/ „I/ON"
6 Storage for trigger gun
7 Storage for high-pressure hose
8 Transport handle
9 Storage for spray lance
10 Dosage regulator for detergent
11 Detergent suction hose (with filter)
12 Mains cable with mains plug
13 Detergent Tank
14 Bearing wheel
15 Trigger gun
16 Lock trigger gun
17 High pressure hose
18 Key to detach the high-pressure hose
from the trigger gun
19 Washing brush
20 Spray lance with Dirtblaster
21 Spray lance with pressure regulation
(Vario Power)
22 KÄRCHER Twin Jet
Special accessories
Special accessories expand the possibilities
of using your appliance. Please contact your
KÄRCHER dealer for further information.
Mount loose parts delivered with appliance
prior to start-up.
Illustrations on Page 4
Illustration
Insert the transport handle and screw in.
Illustration
Attach the accessories holder.
Illustration
Insert holder for trigger gun.
Illustration
Push the high pressure hose into the
trigger gun until it locks audibly.
Note: Make sure the connection nipple
is aligned correctly.
Check the secure connection by pulling
on the high-pressure hose.
Fasten the quick coupling for the high
pressure hose to the high pressure con-
nection.
According to the applicable regula-
tions, the appliance must never be
used on the drinking water supply
without a system separator. Use a
suitable system separator manufactured by
KÄRCHER; or, as an alternative, a system
separator as per EN 12729 Type BA. Water
flowing through a system separator is con-
sidered non-drinkable.
Caution
Always connect the system separator to
the water supply, never directly to the appli-
ance!
Note: Impurities in the water can damage
the high-pressure pump and accessories.
For protection, the use of the KÄRCHER
water filter (optional accessory, order no.
4.730-059) is recommended.
Water supply from mains
Observe regulations of water supplier.
For connection values, see type plate/tech-
nical data.
Use a fibre-reinforced water hose (not
included) with a standard coupling.
(Minimum diameter 1/2 inch (13 mm),
minimum length 7.5 m).
- 8
EN
Before Startup
Water supply
17